How to Reset Canon iP110 - Error Ink absorber full [5B00, 5B01] - Guru Merdeka ID

To reset a Canon iP110 printer, you can try the following steps:

• Turn off the printer and unplug it from the electrical outlet. 
• While holding down the Stop/Reset button, turn the printer back on. 
• Continue holding down the Stop/Reset button until the printer starts initializing. Release the Stop/Reset button when printer initialization is complete. The printer should now be reset to  factory defaults

Note: If the steps above  do not help, you may need to refer to your printer's manual or contact Canon support for further assistance.

Operator Call Errors Code

• Blinking of Alarm LED: 8 times
• Error: Warning: The ink absorber becomes almost full. [1700]

Service Call Errors Code

• Cycles of Blinking of Alarm and Power LEDs: 7 times
• Error [Error code]: Ink absorber full [5B00, 5B01]

Solution: Reset the printer

How to Reset Printer Canon Pixma iP110 error ink absorber is full [5B00] [5B01]

STEP 1 - Enter Service Mode

Service mode operation procedures

1. Turn off the Canon printer
2. Please Press and hold the STOP button
3. Please Press and hold the ON button (do not release both buttons)
4. Please Release the STOP button (do not release the ON button)
5. Please While holding the ON button, press the STOP button 5 times, and release the ON and STOP buttons together.

About point  Number 5):

While holding down the ON button, press and release the STOP button 4 times, then  release  the ON and STOP buttons simultaneously while holding down the STOP button. 

Note:

• When the power LED is green,  the printer is ready to go into service mode. 
•  If the power light is not  green, the printer cannot enter service mode. Turn off the printer and  repeat the service mode procedure.

STEP 2 - Reset error code Ink Absorber Full [5B00] [5B01]

To reset error Ink Absorber Full for Printer Canon Pixma iP110 use:

1. Canon Service Tool v.4420 (Recommended)
2. Canon Service Tool v.4720 (Alterative 1)
3. Canon Service Tool v.4718 (Alterative 2)

Because the Canon Service Tool v.4420 is not available, use the Canon Service Tool v.4720 or the Canon Service Tool v.4718 instead. In this post, I`ll display you a way to use the Canon Service Tool v.4720 to reset the Printer Canon Pixma iP110. Follow the hyperlink above to discover ways to reset the Canon Pixma iP110 the use of the Canon Service Tool v.4718.

Reset Canon Pixma iP110 with Canon Service Tools v.4720

Before you running this tool, make sure the printer Canon in the Service Mode position.

1. Download Canon Service Tool v.4720
2. Extract file and open Canon ST4720.
3. Load paper A4,F4 or Letter
4. For your reference in servicing, print EEPROM (1) records earlier than resetting. Wait for the printer to complete printing.
5. Clear Ink Counter, choose MAIN (2) after which click on SET (3). After the ink absorber counter is reset, the counter price is outlined automatically. Wait for the printer to complete printing.
6. Set Destination, choose your Region (4): ASA, AUS, BRA, CHN, CND, EMB, EUR, JPN, KOR, LTN, TWN, USA after which click on SET (5)
7. Print EEPROM (1) records once more after resetting. Wait for the printer to complete printing.
8. Compare EEPROM records earlier than and after reset.
9. If all is going well, near Service Tool
10. Turn off the printer Canon (wait 10 seconds)
11. Turn on printer and printer prepared to use

Related Posts